Sony 4-151-079-11(1) - Manual (Page 27)

27
Ba
si
c O
per
at
ions
27
Recording a TV
Programme to the HDD
This section introduces the basic operation
to record a current TV programme to the
hard disk (HDD). For an explanation of how
to make timer recordings, see page 34.
b
The recording destination is HDD only.
1
Turn on the recorder and your TV.
Then switch the input selector on your
TV so that the signal from the
recorder appears on your TV screen.
2
Press PROG +/– to select the
programme position or input source
you want to record.
3
Press z REC.
The recording mode is automatically set
to DR mode, and recording starts.
To stop recording
Press x REC STOP.
To pause recording
Press X (pause).
To resume recording, press z REC.
To change the recording mode (for
analogue broadcasting only)
Press REC MODE repeatedly to select the
recording mode before recording starts.
Each time you press the button, the display
on the TV screen changes as follows:
For more details about the recording mode,
see page 91.
To watch another TV programme while
recording
Set your TV to the TV input using the
TV t button (page 20).
b
• After pressing the z REC button, it may take a
short while to start recording.
• It may take a short while for recorder to stop or
pause recording.
• You cannot change the recording mode while
recording.
• If there is a power failure, the programme you
are recording may be erased.
HDD
PROG +/–
REC MODE z REC
x REC
STOP
X
INPUT
[/1
TV [/1
,continued