Sony 2-678-737-13(1) - Manual (Page 42)

42
Chapter 2 Playback and Recording
Chapter 2 Playback and Recording
MARKER BURN
The unit can output to each video jacks and display 4:3
screen marker on the 16:9 screen images. In case of
making an editing tape from the original tape,
[MARKER BURN] can be used.
To set up MARKER BURN
Set [MARKER BURN] in [DISPLAY SET] menu to
[ON].
Notes
• MARKER BURN is effective under the following
conditions.
– While playing back a tape in HDV or an HDV
signal is input via HDV/DV jack, and [DOWN
CONVERT] of [VIDEO OUT] in [IN/OUT REC]
menu is set to [SQUEEZE] or [LETTER BOX].
– When wide signals recorded in DVCAM or DV
format are played back, or wide screen HDV/
DVCAM/DV signals are input to each VIDEO
jacks.
• When [DOWN CONVERT] of [VIDEO OUT] in
[IN/OUT REC] is set to [EDGE CROP], the marker
can not be displayed.
• The markers displayed with EDGE CROP and
MARKER BURN show the available horizontal ratio
range of the 4:3 screen to be cropped. The
displayable image size of the standard 4:3 TV
monitor may appear smaller than the size marked on
the monitor of the unit.
• When the EDGE CROP MARKER and MARKER
BURN are enabled at the same time, the EDGE
CROP MARKER is displayed as priority.
• When you set [MARKER BURN] and [ALLSCAN
MODE] in [DISPLAY SET] menu to [ON] at the
same time, the marker will not appear in the correct
position on LCD monitor. This is not a malfunction.
The marker will be output correctly via each video
jack.
Playback