Sony 2-678-737-13(1) - Manual (Page 54)

Chapter 4
Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer
54
Chapter 4 Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer
Chapter
4
Dubbing to another equipment
using i.LINK jack, Duplication,
Audio Dubbing, and Connecting
with a Computer
This section describes the connections and settings
necessary to perform dubbing on other equipment,
using the unit as a video player.
Connections for Dubbing
Connect the unit to the recorder as shown right using
an i.LINK cable.
The signal flow is automatically detected so you do not
need to make separate connections for input and
output. Also, connecting the unit to an editing
controller via HDV/DV jack, you can configure a
digital non-linear editing system.
For connections of the editing controller and the unit, refer
to the editing controller instruction manual.
Before dubbing, you must set the format in which you
want to output signals. Perform [HDV/DV SEL] (page
67) and [i.LINK SET] (page 69) settings in [IN/OUT
REC] menu.
For details, refer to “Compatibility of HDV, DVCAM, and
DV Formats” (page 93).
To dub a tape recorded in HDV format using duplicate
function on such as DSR-25/45/50, select [DVCAM]
in [HDV
t DV CONV] of [i.LINK SET] in [IN/OUT
REC] menu.
Dubbing to another equipment using i.LINK jack
HVR-M25 (rear panel)
Monitor
i.LINK cable (not supplied)
i.LINK jack
Digital video
equipment with an
i.LINK jack
: Signal flow
Monitor