Sony 2-678-737-13(1) - Manual (Page 55)

Chapter 4
Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer
Chapter 4 Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer
55
There are some limitations to down convert a tape
recorded in HDV format to DVCAM format.
For details, see “i.LINK SET” on page 69.
Notes
• If you output pictures in the playback pause mode
when connected with an i.LINK cable, recorded
images may appear distorted.
• When the tape is recorded in HDV format, the picture
is output as a simplified picture during playback in
various speeds (page 37).
• When connected with an i.LINK cable, you cannot
output only pictures or sounds separately.
• When you duplicate down converted signals from
HDV to DVCAM on an HDV/DV cassette in
DVCAM format, the available recording time is
reduced to about 2/3 of the recording time indicated
on the tape. However, when a DVCAM cassette is
recorded using DVCAM format, the available
recording time is the same as the recording time
indicated on the DVCAM cassette.
Dubbing procedures
1
Prepare the unit.
Refer to “Settings for Recording” on page 45.
2
Prepare the recorder.
If the recorder has an input selector switch, select
an input.
For details, refer to your recorder’s instruction manual.
3
Start playback on the unit and start recording on
the recorder.
For details, refer to your recorder’s instruction manual.
4
When dubbing is finished, stop recording on the
recorder, and then stop playback of the unit.