Sharp R-1200m - Manual (Page 10)

10
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S
Utilization of the carton may make installation easier.
1. Place carton upside down. See Figure 10.
2. Using cutting line around the carton, cut into two pieces (A) and (B).
See Figure 11.
3. Position oven to assist in mounting to the wall. See Figure 12.
Figure 11
Figure 10
Figure 12
Two people are recommended to attach the Microwave Oven to the Mounting Plate.
1. Thread the Power Supply Cord through the hole made in the bottom of the top cabinet. Install the oven by
snapping it onto the Mounting Plate. See Figure 13.
2. Use two Tapping Screws 5 to secure the levers that are on the bottom of the oven. See Figure 14.
3. Use two Top Cabinet Screws 3 and two Flat Washers 6 , supplied in the INSTALLATION HARDWARE, to
attach the unit to the top cabinet. See Figure 15.
4. Make a bundle of the Power Supply Cord and attach it to the inside of the cabinet using the Power Cord Hanger
4 . See Figure 15.
Figure 13 Figure 14
Figure 15
NOTE:
Screw length has been designed to
accommodate 3/8" and above cabinet
depth. If less, screw must be cut to
required length.
MOUNTING OVEN TO THE WALL
8 PREPARATION AND USE OF THE CARTON TO
ASSIST IN THE INSTALLATION OF THE
MICROWAVE OVEN
(A)
(B)
Top Side Cutting Line
3 4
6