Sony DAV-LF10 - Manual (Page 24)

24 GB
Required cords
Video cord for connecting a TV
Audio/video cords (not supplied)
When connecting a cord, be sure to match the color-coded sleeves to the appropriate jacks on the
components.
Terminals for connecting video components
Notes
• The video signal is output as below:
– When [COMPONENT OUT] is set to [INTERLACE] in [SCREEN SETUP] (page 89) (default)
The video signal is output from the S VIDEO and VIDEO jacks of MONITOR OUTPUT.
– When [COMPONENT OUT] is set to [PROGRESSIVE] in [SCREEN SETUP] (page 89)
The video signal is output from the COMPONENT VIDEO OUT jacks only.
• When you connect a VCR or digital satellite receiver to the VIDEO/SAT jacks of the subwoofer, change the
function to VIDEO or SAT (page 81).
• The S VIDEO jack and COMPONENT VIDEO OUT jacks output video signals only when DVD is selected (by
pressing FUNCTION repeatedly until “DVD” appears in the front panel display).
Tips
• When using the S video jack instead of the video jacks, your TV monitor must also be connected via an S video
jack. S video signals are on a separate bus from the video signals and will not be output through the video jacks.
• When using the COMPONENT VIDEO OUT jacks (Y, P
B
/C
B
, P
R
/C
R
) instead of the video jacks, your TV monitor
must also be connected via COMPONENT VIDEO OUT jacks (Y, P
B
/C
B
, P
R
/C
R
). If your TV accepts progressive
format signals, you must use this connection and set [COMPONENT OUT] to [PROGRESSIVE] in [SCREEN
SETUP] (page 89).
Step 3: TV and Video Component Hookups
Connect the To the
TV (VIDEO IN) MONITOR OUTPUT (VIDEO) jack
VCR (VIDEO/AUDIO OUT) VIDEO (VIDEO IN/AUDIO IN (L/R)) jacks
Digital satellite receiver
(VIDEO/AUDIO OUT) SAT (VIDEO IN/AUDIO IN (L/R)) jacks
or OPTICAL DIGITAL IN jack
Yellow
White (L/audio)
Red (R/audio)
Yellow (Video)