Sony DAV-LF10 - Manual (Page 79)

O
th
e
r O
p
era
tions
79 GB
Controlling the TV
You can control your TV using the buttons
below.
Using the number buttons for
controlling the TV
When you set the remote to the TV mode, you
can use the number buttons for controlling the
TV.
Press the TV button.
The TV button turns red and the remote is set to
the TV mode. You can select the TV channels by
using the number buttons.
>10 is for selecting the channel number greater
than 10.
To cancel the TV mode, press the TV button
again.
Notes
• Depending on the TV, you may not be able to control
your TV or to use some of the buttons above.
• The TV button turns off when you do not operate the
remote for 10 seconds.
Tip
Depending on the TV manufacture, the following
method also works. Press >10, then the number. (For
example, for channel 25, press >10, then 2 and 5.)
This function allows you to turn on your SONY
TV and this system, change the system mode to
“DVD,” and then switch the TV’s input source
you set with one button push.
Preparation
Register the TV’s input source connected to this
system.
Press and hold TV/VIDEO while entering
the code for the TV’s input source to
connect this system (see table below)
using the number buttons.
The TV’s input source is selected.
When you successfully set the TV’s input source
code, the TV button flashes twice slowly. If the
setting is unsuccessful, the TV button flashes
five times quickly.
By pressing You can
TV [/1 Turn the TV on or off.
TV/VIDEO Switch the TV’s input source
between the TV and other input
sources.
TV VOL +/– Adjust the TV volume.
TV CH +/– Select the TV channel.
Using the SONY TV DIRECT
(THEATRE SYNC) Function
TV CH +
TV/VIDEO
Number
buttons
With cover opened.
SONY TV
DIRECT
(THEATRE
SYNC)
TV button
continued