Sony 3-283-045-11(1) - Manual (Page 11)

11 GB
Ge
tting Star
te
d
Step 1: Assembling the Speakers
Before connecting the speakers, attach the speaker stand to the speaker.
(For the front and surround speakers)
Use the parts as follows:
• Front and surround speakers (4)
• Speaker cords (4, red/white/blue/gray)
• Posts (4)
• Bases (4)
• Mounting plates (4)
• Post covers (4)
• Screws (large, with washer) (8)
• Screws (small) (12)
Although the rear layout of the front speaker is slightly different from it of the surround speaker, the
way of the assembling is the same. (The illustrations in the following steps are for the front speakers
as example.)
About how to connect the speaker cords to the SPEAKER jacks, see page 20.
Note
• Spread a cloth on the floor to avoid damaging the floor when you assemble the speakers.
Tip
• You can use the speaker without the speaker stand by installing it on the wall (page 16).
1
Thread the speaker cord through the hole in the base and post.
The connector and color tube of the speaker cords are the same color as the label of the jacks to be
connected.
Use the speaker cords as follows:
• Front speaker (L): White
• Front speaker (R): Red
• Surround speaker (L): Blue
• Surround speaker (R): Gray
Be careful with the orientation of the post. Thread the speaker cord (and the speaker system cord)
into the end of the post that has two holes.