Sharp AR-407 - Manual (Page 177)

8-27
CHAPTER
8
Disabling of Second Tray Output in Interrupt
This program is used to disable output of copies to the second tray in
interrupt copying for an optional dual tray output unit (AR-TR1).
To disable output of copies to the second tray in interrupt
copying, press the check box of “DISABLING OF SECOND
TRAY OUTPUT IN INTERRUPT.” to display a check mark in
the check box.
To enable output of copies to the second tray, press the
check box of this program again to clear the check mark in
the check box.
Disabling of Auto Power Shut-off Mode
The auto power shut-off mode is used to turn off the power automatically
once a programmed length of time has elapsed without any copier
operation after the last copy of a run is made or power is turned on. This
mode lowers the user’s electricity bill, reduces waste of natural
resources, and cuts down on environmental pollution.
Depending on how the machine is to be used, you may wish for some
reasons to disable this mode. This can be done using this program.
NOTE:
Since we would like you to fully understand the purpose of this mode,
we suggest that you enable this mode and set the most appropriate
time using program “AUTO POWER SHUT-OFF TIMER” (page 8-21).
To disable the auto power shut-off mode, press the check
box of “DISABLING OF AUTO POWER SHUT-OFF MODE.” to
display a check mark in the check box.
To restore the mode, press the check box of this program
again to clear the check mark in the check box.
Disabling of Beep When Keys Touched
This program is used to enable or disable the beep function. If this
function is enabled, a beep sound will be produced when you press a
key on the operation panel including the touch panel.
To disable the beep function, press the check box of
“DISABLING OF BEEP WHEN KEYS TOUCHED.” to display
a check mark in the check box.
To enable the beep function, press the check box of this
program again to clear the check mark in the check box.
KEY OPERATOR PROGRAMS
KEY OPERATOR’S GUIDE
Key operator programs