Sony BRAVIA KDL-26L5000 - Manual (Page 23)

Usi
ng Fe
ature
s
23
Wide Mode
The Wide Mode feature allows you to select
the screen display to your preference. Based on
the original signal source, you may see black
bars around the picture or just on the both sides
of the screen. Sometimes you will see the
picture fill the full screen. This is due to the
signals your TV receives.
You can manually select available Wide
Mode settings as you watch your TV by
pressing the WIDE button on your remote
control or you can set your TV to Auto Wide.
To set Auto Wide
Press MENU then go to the Screen settings.
Select Auto Wide and set to On.
To change the Wide Screen Mode
Press WIDE repeatedly to cycle through the
available modes.
Normal is available with 480i or 480p sources
only.
Wide Mode with PC
Wide Mode is also available for the PC
settings. When a PC is connected to the TV
and PC input is selected, you can change the
PC Screen settings.
To change the Wide Screen Mode for
PC Timing
Press WIDE repeatedly to cycle through the
available modes while in the PC input mode.
4:3 Original source 16:9 Original source
Standard-
definition source High-definition source
m m
Wide Zoom Wide Zoom
Normal Normal
This mode is not available.
Full Full
Zoom Zoom
Incoming PC signal
m
Normal
Full 1
Full 2
Screen PC
PC Settings
Wide Mode
Auto Adjustment
Phase
Pitch
Horizontal Center
Vertical Center
Normal
0
0
0
0
800 × 600
• Use the Auto Adjustment to adjust
the display position and phase of the
picture when the TV receives an input
signal from the connected PC.
• Change the screen mode to
accommodate for the display of the
main window in PIP feature.