Cd p lay b a ck listening to a cd (continued) – Sharp XL-35H User Manual

Page 18

Advertising
background image

02/9/11

XL35H_H_E2.fm

E-11

ENGLISH

XL-35H

C

D

P

lay

b

a

ck

Listening to a CD (continued)

To interrupt playback:
Main unit operation:
Press the

button.

To resume playback from the same point, press the

button again.

Remote control operation:
Press the button.
To resume playback from the same point, press the button.

To stop playback:
Press the button.

To remove the CD:
Whilst in the stop mode, press the CD EJECT button.

After use:
Press the ON/STAND-BY button to enter the power stand-by mode.

Caution:

!

If a disc is damaged, dirty, or loaded upside down, "NO DISC" or
"READ ERR" will appear on the display.

!

Keep foreign objects out of the CD compartment.

!

Subjecting the unit to shock or vibration may cause mistracking.

!

When the unit is not being used, be sure to close the CD compart-
ment. If it is left open, the lens may be covered with dust and the unit
may not operate properly.

!

If TV or radio interference occurs during CD operation, move the unit
away from the TV or radio.

"

Headphones

"

Care of compact discs

Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.

!

Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.

!

Keep your discs away from direct sunlight, heat, and excessive
moisture.

!

Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.

"

To locate the beginning of a track

!

Before plugging in or unplugging the head-
phones, reduce the volume.

!

Be sure your headphones have a 3.5 mm (1/8")
diameter plug and are between 16 ohms and 50
ohms impedance. The recommended imped-
ance is 32 ohms.

!

Plugging in the headphones disconnects the
speakers automatically. Adjust the volume using
the VOLUME control.

To move to the beginning of the next track:

Press the

button for less than 0.5 seconds during playback.

!

You can skip to any track by pressing the

button repeatedly until the desired track
number appears.

To restart the track being played:

Press the

button for less than 0.5 seconds during playback.

!

You can skip to any track by pressing the

button repeatedly until the desired track
number appears.

NO

YES
Correct

Advertising