Sundance Spas ALTAMAR 880 - Manual (Page 54)

Page 48
880 SERIES
13.0 Programming instructions
13.1 Programming Filter/Circulation Pump
The Sentry control system allows you to easily adjust two separate
aspects of filter/circulation pump operation:
The time of day (start time) the filter/circulation pump turns on. •
The length of time (duration) the filter/circulation pump operates. •
The factory default start time is 12:00AM (midnight). The default duration
is 12 hours. To make adjustments:
Standard Mode - in this mode, press the • (CYCLe) button
once;
Economy Mode - in this mode, press the • (CYCLe) button five
times to enter the filter/circulation pump programming mode.
The LCD screen will display “Circ”. At this time the system is ready to
accept your changes.
1. Press the (SeLeCT) button once. The previously programmed
start time appears on the LCD display.
2. Press the (UP) or (dOWN) buttons to adjust the start
time in 30-minute increments.
3. Press the (SeLeCT) buttons to program duration.
4. Press the (UP) or (dOWN) buttons to program the
duration time in 1 hour increments.
5. Press the (diSPLAY) button to save changes and recall the
main water temperature display.
Note: If no button is pressed within 30 seconds, all changes are
recorded and the screen automatically returns to the standard water
temperature display. When the standard mode is selected (Section 12.3),
the filter/circulation pump automatically turns on for a heat call regardless
of the pump’s programmed start time and duration.
13.2 Programmable Filter/Heating Cycles (economy Mode Only)
Your hot tub comes with four 30-minute filter cycles which activate the
filter/circulation pump while in economy mode. These cycles are factory
programmed to start at 6:00 AM, 12:00 (noon), 6:00 PM, and 12:00
(midnight). The control system allows you to easily adjust two separate
aspects of each cycle:
The time of day at which it begins; •
The duration of the cycle. •
Note: When “Economy” mode is selected (Section 12.3), the heater
activates only during a programmed filter cycle period. When a Summer
Logic condition is active (page 49), the filter/circulation pump will turn on
for all programmed filter cycles.