Sony PEGA-WL100 - Manual (Page 36)

36
Symptom
The data transfer rate is
slow.
You forget a WEP
(encryption) key.
You cannot send or
receive email.
You cannot perform a
HotSync operation.
You cannot browse
homepages.
Cause/Remedy
• There is an obstacle that could block off
radio waves (e.g., metal plate, concrete
block) between your CLIÉ handheld and
the access point.
p Move your CLIÉ handheld and/or the
access point to a different place.
p Disable the power saving mode.
(This will increase the power
consumption. Be careful of the
remaining battery power).
• There is a device operating at the 2.4 GHz
band of frequencies (microwave oven,
Bluetooth-enabled device, etc.) around
the CLIÉ handheld.
p Increase the distance between the
device and the CLIÉ handheld or turn
off the power of the device.
p After changing all the settings of the
access point to its factory default setting,
set the access point again.
To restore the default settings, see the
operating instructions of the access point.
p Check the settings of the emailing
software you are using.
For details on how to set the emailing
software, see its operating instructions.
p Check the settings of HotSync.
For details on how to set HotSync, see the
operating instructions supplied with your
CLIÉ handheld.
p Check the settings of the web browser
you are using.
For details on how to set the web
browser, see its operating instructions.
Tip
You can view the data of the communication preferences.
While performing communications using your CLIÉ handheld in which this
Wireless LAN card is inserted, show the [Network] screen of [Preferences].
Select [Option] on the menu, then select [View Log].