Sony SLV-ED10MJ - Manual (Page 40)

40
Additional Information
Troubleshooting
Additional Information
If you have any questions or problems not covered below, please consult your
nearest Sony service facility.
Power
Clock
Playback
Symptom
The ON/STANDBY switch
does not function.
The power is turned on but the
VCR does not operate.
The clock has stopped and
“–:– –” lights in the display
window.
The playback picture does not
appear on the TV screen.
The playback picture has no
colour or unusual colours.
The picture is not clear.
The picture rolls vertically
during picture search.
The picture has no sound.
Remedy
• Connect the mains lead to mains securely.
• Moisture condensation occurs. Turn the power off,
unplug the mains lead and leave the VCR to dry for
over one hour.
• The clock stops if the VCR is disconnected from the
mains for more than eight hours (SLV-ED10MPS/PS
only) or 24 hours (SLV-ED10ME/MJ/SG only). Reset
the clock (and timer).
• Make sure the TV is set to the video channel. If you are
using a monitor, set it to video input.
• Set the PAL/MESECAM option in the SET UP MENU
according to your local colour system.
• Adjust the tracking with the TRACKING +/– buttons.
• Make sure the colour system is set to the system that
the tape was recorded in.
• The video heads are dirty (see page 42). Clean the
video heads using the Sony T-25CLD, T-25CLW or E-
25CLDR video head cleaning cassette. If these cleaning
cassettes are not available in your area, have the heads
cleaned at your nearest Sony service facility (a
standard service charge will be required). Do not use a
commercially available liquid type cleaning cassette
other than Sony’s, as they may damage the video
heads.
• The video heads may have to be replaced. Consult
your local Sony service facility for more information.
• Adjust the vertical hold control on the TV or monitor.
• The tape is defective.
• If you made A/V connections, check the audio cable
connection.