Sharp FP-P60CX - Manual (Page 16)

E-14
POWER ON/OFF Button
• W h e n y o u p r e s s t h e
POWER ON/OFF Button, a
short beep will sound and
operation will start in AUTO
Mode.
• Unless the power cord has
b e e n u n p l u g g e d t h e
operation starts from the
previous mode the unit was
operated in.
• To stop, press the POWER
ON/OFF Button again.
A long beep will sound and
operation will stop.
Auto (Fan Speed) Button
The fan speed switches au-
tomatically depending on the
amount of impurities in the air.
Manual (Fan Speed) Button
T h e f a n s p e e d c a n b e
switched among SILENT,
MEDIUM and MAX settings.
Transmitter
Filter Reset Button
Pollen Mode Operation
Button
See Page E-12
Off Timer Button
The set time switches every time
the button is pressed as shown
below.
• The indicator light shows the
remaining time.
• The unit will stop operation
when the time is up.
1 hour
Cancel
4hours
8 hours
Plasmacluster Ion Mode Selections
AUTO
When pressed, the unit will switch between Clean
Mode and the Ion Control Mode automatically de-
pending on the amount of impurities in the air as
detected by the odor sensor. Clean Mode will op-
erate for 1 minute when the Auto function is
selected.
ION CONTROL
When pressed, the unit will constantly operate in
Ion Control Mode.
The Plasmacluster Ion Indicator Light is green.
CLEAN
When pressed, the unit will constantly
operate in the Clean Mode, in which
the same numbers of positive and
negative ions are discharged. The
Plasmacluster Indicator Light is blue.
REMOTE CONTROL OPERATION
OPERATION
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• NIGHT MODE
• Quick CLEAN
• LIGHTS ON/OFF
Plasmacluster Ion mode
selections
• AUTO
• CLEAN
• ION CONTROL
• OFF
OFF
The generation of ions will be
ceased and the Plasmacluster
Indicator Light will go out.
QUICK CLEAN Button
See page E-12
LIGHTS ON/OFF Button
Switches the Plasmacluster
Indicator Light and CLEAN-
SIGN Light either ON or OFF.
NIGHT MODE Button
See page E-12
When the Washable Active
Carbon Filter is cleaned and
reinserted into the main unit,
press the Filter Reset Button.