Samson AH1/QE - Manual (Page 4)

If you’ve had some prior experience using wireless systems, these QuickStart instructions will get you up and running with your
AirLine system in a matter of minutes! Detailed instructions for setting up and using your AirLine system can be found on page 16 of
this manual, and the “Guided Tour” sections on pages 4 - 16 provide full descriptions of all AirLine component controls and displays.
1. Make sure that the supplied receiver and AH1 transmitter are factory preset to the same channel.
2. Physically place the receiver where it will be used (if desired, the AR1 receiver model can be wall-mounted using the supplied
holder) and extend its antenna(s) vertically.
3. Set the power switch on your UH1 transmitter to the “off” position (away from the arrow) and place a fresh battery in it. Then turn
the transmitter back on momentarily; its LED will flash once and then go off if the battery is sufficiently strong. Once battery strength
is verified, turn the transmitter off again.
4. If you are using an AH1 headset microphone, position it correctly as per the illustrations on page 15. If you are using an AirLine
UHF Wind Instrument System, clamp the horn mic to your instrument as described in the supplied Audio-Technica owners manual.
5. Turn your audio system off and make the physical cable connection between the receiver’s balanced or unbalanced output jack
(if necessary, both can be used simultaneously) and a mic level audio input of your amplifier or mixer. If your system contains a UR1
or UM1 receiver, be sure to set its Audio Output Level switch correctly.
6. Turn the Volume, Level or AF Level knob on the receiver completely counterclockwise. Connect the supplied AC adapter to the
receiver and plug it in (or place a fresh battery in the UM1 receiver), but leave its power off for the moment.
7. Turn on the receiver. If your system contains an AR1 or UR1 receiver, its “Power” LED will light steadily red. (Note: the UM1
receiver has no such LED.)
2
Samson AirLine
QuickStart
ENGLISH