Sharp MD-MT821 - Manual (Page 40)

E r r o r m e s s a g e s M e a n i n g R e m e d y
B a t t EMPTY
l The battery run down. l Charge the rechargeable battery or
(Lo BAT-T)
replace the alkaline battery (or use the
AC adaptor for p o w e r
B L A N K D I S C l Nothing is recorded. l Replace the disc with a recorded disc.
( B L A N K )
Can’t COPY l No copy can be made because of the l Record using the analog cable.
(Not REC) SCMS copyright system.
Can’t EDIT l A track cannot be edited l Change the stop position of the track
and then try editing It.
Can’t REC
l Recording cannot be performed
(Not REC)
correctly due to vibration or shock in
l Re-record or replace It with another
recordable disc
the unit
Can’t WRITE l Editing is impossible. l Check the number of tracks.
D E F E C T
l The disc is scratched. l If the sound you hear is not right, try
recording again
( D E F E C T ) l replace the disc with another
recordable d i s c
Din U N L O C K
( U N L O C K )
l Poor connection of the digital cable. l Connect the digital cable securely.
DISC FULL
l The disc
IS out of recording space. l Replace it with another recordable disc.
POWER ?
P R O T E C T E D
l Improper power is being supplied.
l The MD is write protected.
l You tried to record without loading an
MD.
l Use one of the specified power
sources.
l Move the write protection knob back to
its original position.
l Load a recordable MD.
l A playback-only MD was loaded and
the REC button was pressed when the
l Replace it with a recordable MD.
Power was off.
R E A D E R R O R l The disc is damaged. l Reload the disc or replace It.
l Replace it with another recorded d i s c
l Since a track number is currently being
located or written to, the unit cannot
l Wait for a while and try the operation
STEM ERR l You have come to the conclusion that
(E-SYS) the unit is out of order.
l To have it repaired, go to the distributor
where you purchased the unit.
EMP OVER l The temperature is too high. l Turn off the power, and wait for a while.
;E-TEMP)
TOC ERROR l A large portion of the disc has been
damaged.
l Replace it with another recorded disc.
(E-TOC)
c e
ation (track names,
e e c t .
k has been protected from
r e p l a c e it with a n o t h e r recordable d i s c
l edit the track with the device on which
i t w a s recorded
d d i s c
Tr. Protect
l The trac
being erased .
TOC ERROR l A large portion of the disc has been l Replace it with another recorde
damaged.
(E-UTOC)
l There is an error
? DISC
l Adiscn
music was
(?DISC) l There is an e r r
disc.
in the recorded s i g n a l
erase all of the signal errors, and then
try recording again
which contains data other than l A disc which contains non-music data
played c a n be played
o r the signal from the l Re place it with another recorded disc.
( ): Error messages seen on the remote control.