Sony NVX-P1 - Manual (Page 7)

7
Installing the unit
Before you start, choose the position on the
windshield that is clearly visible to the driver
without obstructing the road view, and make sure
all surfaces are clean and dry.
Suction mount
1
Slip the locking nut over the ball joint
with the flat side facing upwards.
2
Snap the cup joint of the holder onto
the ball joint and half tighten the
locking nut.
3
Clean and dry the surface of the
suction cup with the alcohol swab,
hold it firmly against the windscreen,
then press the lever.
4
Align the 2 slots on the underside of
the unit with the tabs on the holder
and push to snap the unit into place.
5
Pull the GPS receiver out to a
horizontal position.
6
Set the angle and tighten the locking
nut firmly.
Locking nut
Ball joint
1
2
3
Holder
1
2
GPS
receiver