Shindaiwa 82085 - Manual (Page 10)

10
English
KICK GUARD® TO BAR INSTRUCTIONS
For saws with Kick Guard® and symmetrical or asymmetrical low-
kick type guide bars.
Install bolt (A) in rear hole (B) of Kick Guard® and through front 1.
hole (C) in guide bar.
2. IMPORTANT: Dimple in Kick Guard® (D) must engage recess in
guide bar (E).
Tighten nut (F) and bolt (A) until snug. Make certain Kick Guard® 3.
is flush against guide bar.
GUIDE BAR AND SAW CHAIN-INSTALL/ REMOVE
WARNING DANGER
Saw Chain is sharp! Always wear gloves when handling assem-
bly, otherwise serious personal injury may result.
Move chain brake lever (G) fully rearward to unlock chain brake. 1.
Remove two guide bar nuts (H). Turn tension adjustment screw (J) 2.
counterclockwise 2 to 3 turns if bar and chain are installed.
IMPORTANT
Always loosen guide bar nuts before turning chain tension adjuster, other-
wise clutch cover and tensioner will be damaged
Push clutch cover (K) forward, pull rear of cover out slightly, then 3.
remove.
Remove guide bar and saw chain if necessary. 4.
Mount guide bar (L) on studs, and slide toward sprocket to make 5.
saw chain installation easier. Install saw chain (M) over clutch and
place around sprocket and guide bar as shown, with cutters on
top of guide bar facing forward.
NOTE: See “MAINTENANCE AND CARE” instructions for guide
bar, sprocket, and saw chain maintenance.
Align holes of clutch cover (K) with guide bar studs, and tensioner pin 6.
(N) with lower guide bar adjuster hole. Install cover, then press and
hold rear of cover to fully seat. Tighten guide bar nuts finger tight.
L
M
N
G
H
J
K