Shindaiwa 82085 - Manual (Page 24)

24
English
For setting saw chains, round file (4 mm ø: 5/32”) and flat file are used.
To keep correct position and correct angle, use the file holder.
■
Round file and flat file are available from your Shindaiwa Dealer. -
File cutters as below.
■
Type : 91VG
HOLD FILE HOLDER LEVEL
Depth gauge
ONE FIFTH OF FILE DIAMETER REMAINS
ABOVE CUTTER EDGE
To sharpen other type chain, follow chain manufacturer’s instructions
30°
PUSH FILE AS SHOWN
Keep this angle
1/5
90°
SETTING THE SAW CHAIN
The following combinations may be used on 326T.
C
hain anD
g
uiDe
b
aR
C
ombinations
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.
IMPORTANT
If your kick guard is damaged or lost, contact your Shindaiwa dealer for a replacement.
WARNING DANGER
Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as “LOW-KICKBACK” that meets the ANSI B175.1-2000 Standard and the guide bar
specified.
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
Model Bar Length Low Kickback
Guard Bar
Low Kickback Saw Chain
Bar P/N Chain P/N Links Type Pitch Gauge
326T
12” 120GPEA041 91VG-45 45
91VG 3/8” .050 14” 140GPEA041 91VG-52 52
16” 160GPEA041 91VG-57 57