Sierra Raven EDGE - Manual (Page 108)

Configuration Commands
Rev 3.0B Feb.08 104
MVOPT=n
Modbus Variant Option: Sets various behavioral options when
dealing with a Modbus‐variant protocol. This parameter is
used when the when MD is set to hex 63. Cannot be configured
in AceManager.
• n=0 : No special action (Default).
• n=1 : Skip leading zeroes in Modbus packets.
MVTYP=n
Modbus Variant Type: The data‐type of the RTU ID in a
modbus‐variant protocol. This parameter is used to define the
data‐type of the RTU ID in Modbus‐like protocol data packets.
This parameter is used when MD is set to 63.
• n=0 : Binary (Default)
• n=1 : ASCII Hex
• n=2 : ASCII Decimal
RKEY=n
Enable/disable MDS Radio transceiver keying. Radio keying is
designed to assert CTS when a packet is received, delay the
time as specified, send the data out the serial port, wait the
same amount time, drop CTS. This way, the CTS signal can be
used to key a transmitter on and give it time to reach its power
level before data is sent to it. Delay interval is specified in S221.
• n=0 : Off (Default).
• n=1 : On.
Addr List
Figure 1-13: AceManager : Addr List