Sierra Raven EDGE - Manual (Page 46)

Configuring your Raven
Rev 3.0B Feb.08 42
b. Type AT and press Enter. You should get a reply of
“OK” or “0”.
c. To see what you are typing as you type it, you will
need to turn on the echo and verbose mode. Type
ATE1V1 and press Enter.
d. If you get a reply of “OK”, then you entered the
command successfully. If you get a reply of “0” or
“ERROR”, try entering the command again.
AT Commands
When using a terminal application, you will need to manually
type in each command.
• For most commands, when you are entering them using a
terminal connection, you will need to preface the
command with AT (exceptions are noted), i.e. ATA which
is listed as A.
• Some commands have specific parameters while other
commands will take whatever you type.
• Required variable parameters are denoted with italicized
text, example, Dn. The n is variable.
• Acceptable parameters and/or specific formats are listed
with each command.
• Most commands with parameters can be entered with ? to
read the current value (for example, AT&D? will respond
with “2” if the default has not been changed).
• Optional parameters are denoted with square brackets [ ].
• AT Commands are not case sensitive. A capital “E” is the
same as a lower‐case “e”.
• When you are using a terminal connection, if you enter a
command which is recognized by the Raven, it will
respond with “OK”. If the command is not recognized, the
response will be “ERROR”.
• Those commands applicable only to certain model
numbers of the Raven will be noted.
Caution: Symbols listed with commands, such as *, /, &, or ?, are
part of the command and must be included. Commands with symbols
other than * may require PassThru mode.