Samsung DJ68-00264B - Manual (Page 14)

14_ Maintain tools and filter
Maintain tools and filter
You should check your vacuum cleaner’s rotating floor brush and drive belt
regularly for wear or damage. You should also clean the brush and brush ends
of strings, hair, and carpet fibers. These can wrap around the brush and hamper
its ability to effectively clean your carpet. Also remove any debris that has
accumulated under the brush cover.
check rotating Floor Brush and drive Belt
1. Unplug cleaner from electrical outlet.
2. Recline handle and turn vacuum cleaner over so
bottom side is up.
3. Remove the six screws as shown with a phillips head
screwdriver. Lift the brush cover off.
4. Grasp rotating floor brush at both ends and lift.
5. Clean strings, hair and other debris from rotating
floor brush, paying particular attention to brush ends.
6. Clean strings, hair and other debris from motor pulley
and drive belt areas.
7. Check drive belt carefully for wear, cuts or stressed
areas.
8. Check air passageway for obstructions. Remove
debris from this area.
Rotating drum-brush could cause the fringe of a rug to become tangled within
cleaner.
Use caution and turn off the drum-brush when vacuuming throw rugs with
fringe.
CAUTION
replace drive Belt
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from vacuum
cleaner grasp old drive belt and remove from motor
pulley. Discard old drive belt.
3. Place new drive belt over motor pulley and stretch
other end over rotating floor brush in the space
between the bristles.
4. Place ends of rotating floor brush down into slots
on sides as shown.
5. T urn rotating floor brush by hand several times in
the direction of motor pulley. If properly installed,
drive belt will center itself on rotating brush crown.
6. Reposition brush cover and screws. Tighten
screws securely.