Samsung DVD-V2500 - Manual (Page 15)

Dynamic Compression
29
Dynamic Compression restrains the dynamic range of sound, i.e.
the difference between the calm and noisy passage of a DVD audio
track.
1 Open “SETUP MENU”
With the DVD in stop mode, press the SETUP button.
2 Select “DVD Setup”
Using the up/down and left/right buttons, move the selection cursor
to “DVD Setup,” then press ENTERto select.
3 Set “Dynamic Compression”
Move the selection bar to “Dynamic Compression,” then press
right or left to select from the following options:
• On - The total dynamic range of the DVD soundtrack will be
compressed, so quiet passages will be louder and loud
passages will be softer.
• Off – The original dynamic range will be preserved.
DTS
28
If your A/V receiver is equipped with a DTS decoder, your DVD-
VCR can output DTS digital sound, but you MUST enable this
feature in the menu system.
NOTE: Select “On” ONLY if you have connected a DTS-equipped
A/V receiver to the DIGITAL AUDIO OUT (optical or coaxial) on
the DVD-VCR back panel.
1 Open “SETUP MENU”
With the DVD in stop mode, press the SETUP button.
2 Select “DVD Setup”
Using the up and down buttons, move the selection cursor to “DVD
Setup,” then press ENTERto select.
3 Set “DTS”
Move the selection bar to “DTS,” then press right or left to select
from the following options:
• Off - To use your DVD/TV with an A/V receiver NOT equipped
with a DTS decoder.
• On – To use your DVD/TV with an A/V receiver equipped with a
DTS decoder.
On
Off
On
Off
00006A DVD-V2500/XAC-Eng2 11/12/02 7:05 PM Page 28