Samsung S3F80JB - Manual (Page 119)

S3F80JB INTERRUPT STRUCTURE
5-9
PERIPHERAL INTERRUPT CONTROL REGISTERS
For each interrupt source there is one or more corresponding peripheral control registers that let you control the
interrupt generated by that peripheral (See Table 5-3).
Table 5-3. Vectored Interrupt Source Control and Data Registers
Interrupt Source Interrupt Level Register(s) Location(s) in Set 1 Bank
Timer 0 match/capture or
Timer 0 overflow IRQ0 T0CON (see Note)
T0DATA D2H
D1H Bank0
Timer 1 match/capture or
Timer 1 overflow IRQ1 T1CON (see Note)
T1DATAH, T1DATAL FAH
F8H, F9H
Bank0
Counter A IRQ2 CACON
CADATAH, CADATAL F3H
F4H, F5H
Bank0
Timer 2 match/capture or
Timer 2 overflow IRQ3 T2CON (see Note)
T2DATAH, T2DATAL E8H
E6H, E7H
Bank1
P0.7 external interrupt
P0.6 external interrupt
P0.5 external interrupt
P0.4 external interrupt IRQ7 P0CONH
P0INT
P0PND
E8H
F1H
F2H Bank0
P0.3 external interrupt
P0.2 external interrupt
P0.1 external interrupt
P0.0 external interrupt IRQ6 P0CONL
P0INT
P0PND
E9H
F1H
F2H Bank0
P2.7 external interrupt
P2.6 external interrupt
P2.5 external interrupt
P2.4 external interrupt IRQ5 P2CONH
P2INT
P2PND
ECH
E5H
E6H
Bank0
P2.3 external interrupt
P2.2 external interrupt
P2.1 external interrupt
P2.0 external interrupt IRQ4 P2CONL
P2INT
P2PND
EDH
E5H
E6H
Bank0
NOTES:
1. Because the timer 0,timer1 and timer 2 overflow interrupts are cleared by hardware, the T0CON, T1CON and
T2CON registers control only the enable/disable functions. The T0CON, T1CON and T2CON registers contain
enable/disable and pending bits for the timer 0, timer1 and timer2 match/capture interrupts, respectively.
2. If a interrupt is un-mask(Enable interrupt level) in the IMR register, the pending bit and enable bit of the interrupt
should be written after a DI instruction is executed.