Samsung S3F80JB User Manual
Page 332
S3F80JB
DEVELOPMENT TOOLS DATA
20-3
Table 20-1. Components Consisting of S3F80JB Target Board
Block Symbols
OPEN-i500 Connector
J1A
Connection debugging signals between emulator and 80JB
EVA target board.
TEST Board Connector
J2
Connection between target board and remocon application
board.
RESET Block
RESET Push Switch
Generation low active reset signal of 80JB EVA-chip
POWER Block
VCC, GND, S,
nRESET LED
Generation 3.3V with 5V power inserted from external
power source or open –ice (recommend).
STOP/IDLE Display
IDLE, STOP LED
Indicate the status of STOP or IDLE
FLASH Serial Writing
J3
Signal for writing flash ROM in tool mode. Don’t use these
in user mode.
MODE Selection
JP1, JP2
Selection of Flash tool/user mode and Eva/Main-chip mode