Sony R-DG1200 - Manual (Page 34)

34 US
D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\030CON.fm masterpage: Left
STR-DG1200
3-289-135-11(1)
6: Preparing the receiver
and the remote
Connect the AC power cord to a wall outlet.
Note
Before connecting the AC power cord, make sure
that metallic wires of the speaker cords are not
touching each other between the SPEAKERS
terminals.
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1
Press POWER to turn off the
receiver.
2
While holding down TONE
MODE and 2CH/A.DIRECT,
press POWER to turn on the
receiver.
3
Release TONE MODE and 2CH/
A.DIRECT after a few seconds.
After “CLEARING” appears on the
display window for a while,
“CLEARED !” appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Connecting the AC power cord
AC power cord
To the wall outlet
Performing initial setup
operations
1,2 2,3
2,3