Spectra Logic RXT150 - Manual (Page 33)

Chapter 3. Troubleshooting RXT Media
33
8. Replace the ESD panel:
• Slide the end with the cut-outs (Figure 3-16) into its place at the pogo-pad
end of the pack (A in Figure 3-17).
• Pinch the sides of the panel in (B in Figure 3-17) while pushing down (C in
Figure 3-17) until the entire ESD panel lays flat in the pack.
9. Replace the bottom plate on the pack, making sure that it matches up with the
tabs on the ESD panel (Figure 3-18).
10. Use a #1 Phillips screwdriver to tighten the four or six screws that secure the
bottom plate to the media pack.
11. Proceed to Finish on page 36.
Figure 3-16 The cut-outs. Figure 3-17 Replacing the ESD panel.
Figure 3-18 Matching the bottom plate to the ESD panel.
A
B
B
C