Sony WALKMAN MZ-NH1 - Manual (Page 73)

73
Power (bus power) is supplied from the
USB port of the computer. This allows the
recorder to be used without power being
supplied from the rechargeable battery.
1
Insert a recordable disc into the
recorder.
2
Make sure the recorder is stopped and
HOLD is released, and then connect
the dedicated USB cable to the
recorder and the computer.
3
Check the connections.
When the connections have been
properly made, “PC – –MD” appears
in the display of the recorder.
To disconnect the dedicated
USB cable
Be sure to disconnect the dedicated USB
cable as follows. If not, damage to the
data may occur.
1
Make sure that the REC lamp on the
recorder is not lit.
2
Press x on the recorder.
“EJECT OK!” appears in the display.
Depending on the conditions, it may
take some time until “EJECT OK!”
appears in the display.
3
Disconnect the dedicated USB cable.
While pressing the buttons on the
sides of the plug, push the plug
inward, and then pull it outward to
disconnect the dedicated USB cable
from the recorder.
When removing the disc from
the recorder
1
Follow steps 1 and 2 of “To
disconnect the dedicated USB cable”
(page 73).
2
Remove the disc from the recorder.
Computer
To the USB
connecting jack
To the USB port