Sony RDR-GXD310 - Manual (Page 49)

49
Ti
m
e
r Re
co
rd
in
g
◆ Some examples of timer event icon types
are as follows:
(red): Indicates the programme is set as
timer and whole programme can be recorded.
(grey): Indicates the programme is set as
timer but only a part of the programme can be
recorded. (e.g. because of timer setting
overlap).
(red): Indicates the programme is now
recording.
To scroll the EPG display by page (Page mode)
Press / while the EPG display is turned on
to display the previous/next ten channels.
To stop recording during timer recording
Open the remote’s cover and press x REC STOP.
Note that it may take a few seconds for the
recorder to stop recording.
If the timer settings overlap
See page 47.
To confirm, change, or cancel timer recording
See “Checking/Changing/Cancelling Timer
Settings (EPG)” (page 51).
z Hint
The Rec Mode Adjust function also works with this timer
method (page 46).
b Notes
• It is not possible to extend the recording duration time
of the timer recording set using the EPG application
timer setting.
• This recorder is featured with an EPG timer auto extend
functionality that allows EPG timer recordings to be
made in case of broadcast early start (before the
scheduled start time) or broadcast late finishing (after
the scheduled end time).
• The EPG programme start and end time are determined
by the broadcaster.
You can set the recorder to record in 30-minute
increments.
Press z REC repeatedly to set the duration.
Each press advances the time in 30-minute
increments. The maximum duration is six hours.
The time counter decreases minute by minute to
0:00, then the recorder stops recording (power
does not turn off). Even if you turn off the recorder
during recording, the recorder continues to record
until the time counter runs out.
Note that the Quick Timer function does not work
if “TV Direct Rec” is set to “On” in “Features”
setup (page 83).
To cancel the Quick Timer
Press z REC repeatedly until the counter appears
in the front panel display. The recorder returns to
normal recording mode.
Using the Quick Timer function
0:30 1:00 5:30 6:00
(normal recording)