Sharp JW-21MN - Manual (Page 109)

16-14
Function
< Standard network connection >
The operations below using a peripheral device, that is connected to a "n" station, is possible.
- Change programs
- Monitor
- Change parameter memory (only by using JW-14PG/13PG/12PG)
< Expansion network connection >
The operations below using a peripheral device, that is connected to a "n" station, is possible.
- Change programs
- Monitor
- Change parameter memory
(only by using JW-14PG/13PG/12PG)
Operation example
This paragraph describes an operation example using the multipurpose programmer: JW-50PG.
For operations with other support tools, see the attached instruction manuals.
- Connect the JW-50PG to the JW-21MN on the ME-NET.
- Set communication mode
Set the communication mode of the JW-50PG to "Network CONCT." and this enables remote
programming and remote monitor.
Support
tool
n — 2 n — 1 n n + 1 n + 2 m + 1 m + 2 m
ME-NET
*
* The JW-21MN is unusable as a junction station ("n +
2" station and "m" station in the figure above). Use
JW30H (JW-21MN), JW50H/70H/100H (JW-21MN).
Support
tool
n — 2 n — 1 n n + 1 n + 2
ME-NET
Writing data (change program) during operation of the
PC is not available for hazard prevention reasons. Stop
operation of the PC prior to writing data.
Writing data (change program) during operation of the
PC is not available for hazard prevention reasons. Stop
operation of the PC prior to writing data.
Select "Initial setting."
Select "Network CONCT."
Select "COM. set."
(JW-50PG)
(JW-21MN)