Sharp JW-21MN - Manual (Page 54)

11-1
Chapter 11: Setting of Switches and Parameter
11-1 Operation procedure
- Make sure to turn "OFF" the power of the PC prior to setting the module No. switch and station
number switch after installing the JW-21MN.
- Prior to setting the parameters, set the mode of the JW-21MN to "program mode."
- Make sure to write the set parameters into the EEPROM on the JW-21MN after setting.
Start
Set switches of the JW-21MN
Install the JW-21MN
Turn "ON" the power of the slave stations
Set parameter of slave stations
Turn "ON" the power of the master station
Set parameter of master station
End
---------- See pages 11-2 to 11-4.
---------- See page 5-1.
---------- See page 11-22.
---------- See page 11-5.
Remarks