Sharp JW-21MN - Manual (Page 59)

11-6
Corresponding symbols on pages 11-7 to 11-9
- to are equivalent to number of page 11-13.
- Parameter addresses other than above mentioned are reserved areas and prohibited to be changed.
- When the JW-21MN is a slave station, set the top address and the number of sending bytes so
that the data can be within the setting range of each area (see pages 11-7 to 11-12). When any
slave stations are except JW-21MN, see the instruction manual of each device.
Set item
Parameter
address (8)
Initial
value (H)
Details (set range) *
e
Flag area top
address
(communication
and PC operation
status monitor flag)
007764 E0 File address lower digits
Set range: See page 11-11 to
11-12.
- Initial value: 01E0 (H) to
000740 (8) ( 0740) e 0
007765 01 File address upper digits
007766 00 File number
007767 80 Flag output (Yes: 80 (H) , No: 00 (H) )
r
- Start/stop
operation of the
JW-21MN
- Write to the JW-
21MN EEPROM.
007777 01
Select "00, 01, 08, 80, 81" with hexadecimal notation.
(See page 16-12.)
---