Sony PDW-F70 - Manual (Page 29)

29
Connections and Settings
Cha
p
te
r 2
P
repa
ra
ti
ons
For details about the settings of the DSR-2000A/2000AP,
refer to the operating instructions for that unit.
Editing Control Unit Settings
When connecting an editing control unit to use with this
unit, make the following settings.
BVE-700/700A
Set VTR constants as follows.
Remote Control Unit Settings
You can control this unit from an RM-280 Remote Control
Unit.
Connect this unit to the RM-280 with a 9-pin remote
control cable (not supplied), and make the settings in the
following table.
Using XLR Cables (Audio Cables)
Before connecting XLR cables to this unit's analog audio
input and output connectors, always attach the supplied
ferrite cores to the XLR cables. Attach as shown below.
To attach the ferrite core
Loop the XLR cable one time through the ferrite core, on
the side closest to the connector that is connected to this
unit, and fix the ferrite core at the specified position.
DSR-2000A/2000AP
(recorder) settings This unit’s (player) settings
i.LINK button: Lit Remote control switch:
REMOTE
SDTI/i.LINK button: i.LINK Set the setup menu item
INTERFACE SELECT
>REMOTE I/F to “i.LINK”
(see
page 94).
SDSDI OUTPUT HDSDI INPUT
AUDIO INPUT
HDSDI OUTPUT
1 2
REF VIDEO INPUT TIME CODE
POWER
ANALOG HD INPUT
DIGITAL
AUDIO
(AES/EBU)
COMPOSITE OUT AUDIO MONITOR
1/3 2/4
AUDIO OUTPUT
1/3 2/4
R L IN OUT
Y/G P B /R
SYNS
RS232C REMOTE(9P)
P B /B
1/2
INPUT
OUTPUT
CONTROL
3/4
1/2 3/4
S400
- AC IN
MONITOR
MONITOR
AUDIO
i.LINK
VIDEO OUT 3
(SUPER)
S400
COMPOSITE
OUT AUDIO
MONITOR
To analog audio input connector
PDW-F70 (this unit, player)
1
2 : Phono plug – stereo miniplug cable (not supplied)
3 : Phono plug cable (not supplied)
To composite
video input
connector
DSR-2000A/2000AP (recorder)
SD video monitor
SD video monitor
To composite video input connector
To analog audio input connector
2
4
1 : 75
Ω coaxial cable (not supplied)
4 : i.LINK cable (not supplied)
1
3
System
frequency VTR CONSTANT 1
1 2 3 4 5 6 7 8
30P/60I A0 93 00 96 16 16 03 80
25P/50I A1 93 00 7D 16 16 03 80
24P A2 93 00 78 16 16 03 80
System
frequency VTR CONSTANT 2
1 2 3 4 5 6 7 8
30P/60I 0A 07 FE 00 80 5A FF 5A
25P/50I 0A 07 FE 00 80 4C FF 4B
24P 0A 07 FE 00 80 48 FF 48
RM-280 settings Settings on this unit
EDITOR/REMOTE
CONTROL: REMOTE
CONTROL Setup menu item INTERFACE
SELECT >REMOTE I/F (see
page 94): 9PIN/RS-232C
Setup menu item 19
FNC MODE: XDCAM Remote control switch: REMOTE
Remote connector selector
switch: REMOTE(9P)