Sony KD-32NX100U - Manual

DIGIT AL
MODE REC
5
0
Quick Start Guide
4-206-398-02
Thank you for purchasing this
Sony Trinitron Digital Television.
Follow this step by step guide to:
Insert batteries into the remote control.
Connect the aerial to your TV.
Connect a video cassette recorder (VCR) to
your TV.
Tune your TV.
View TV programmes.
KD-32NX100U
1 Checking the supplied
accessories
Batteries
The following accessories are included with your TV.
RF Loopthrough cable
Inserting batteries into
the remote control
Connecting an aerial
and a VCR 3
2
Remote Control
Always remember to dispose of batteries in an environmentally friendly way.
1. Connect your existing aerial lead to the Digital socket marked on the
rear of the TV as shown.
2. Connect the supplied RF loopthrough cable from the socket marked
to the analogue socket marked .
1. Connect your existing aerial to the Digital socket marked on the rear of the
TV as shown.
2. Connect the supplied RF loopthrough cable from the lower socket marked
on the TV to the RF IN socket on your VCR.
3. Connect a lead from the RF output of your VCR to the Analogue socket
marked on the TV.
4. Connect a scart lead from the socket marked on the rear of the TV
to the scart socket of your VCR (refer to VCR instructions).
5. Connect the VCR to the mains socket and switch on.
6. Insert a pre-recorded tape into the VCR and press the ‘PLAY’ button. This
enables the TV to locate and store the video channel during the ‘Automatically
tuning the TV’ procedure.
s 3 3
Connecting an aerial only
Connecting an aerial and a VCR
2 1 3
Place a coin in the slot
provided at the bottom of
the remote control. Turn
anti clockwise to release
the battery compartment. Insert the batteries as
indicated in battery
compartment. Replace the battery
compartment and lock in
place by twisting coin
clockwise in slot.
Supplied RF
loopthrough
cable
RF loopthrough
cable (supplied)
Existing
aerial
RF lead
(not supplied)
Scart lead
(not supplied)