Sony HT-CT350 - Manual (Page 27)

Gettin
g
Sta
rted
27 US
Connecting the FM wire antenna (aerial)
Connect the FM wire antenna (aerial) to the FM 75
Ω COAXIAL jack.
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it as horizontal as possible.
• Do not use the FM wire antenna (aerial) while it is bundled up.
• Insert the FM wire antenna (aerial) fully and firmly to the terminal.
• If you have poor FM reception, use a 75-ohm coaxial cable (not supplied) to connect the subwoofer to an outdoor
FM antenna (aerial) as shown below.
Before connecting the AC power cord (mains lead) of the system to a wall outlet (mains), connect all
the other components and TV to the system.
• After connecting the AC power cord (mains lead), wait about 20 seconds before turning on the power by pressing
?/1.
• Connect the system to an easily accessible AC outlet (mains). Should you notice an abnormality in the system,
disconnect the main plug from the AC outlet (mains) immediately.
To enjoy sound in multi-channel format (DTS, Dolby Digital, multi-channel LPCM), you need to make
the audio output settings of the connected component. Set the connected component to output sound in
multi-channel format. For details on audio output settings, refer to the operating instructions supplied
with the connected component.
Notes
Tip
Connecting the AC power cord (mains lead)
Notes
Setting up the sound output of the connected component
SAT/CATV IN BD IN
HDMI
DIGITAL
TV OUT
ARC
ANTENNA
AM
FM
75 COAXIAL
AUDIO IN
R
L
TV
AUDIO IN
SA-CD/CD
COAX IN
VIDEO
OPT IN
TV SAT/CATV
ONLY FOR
SS-CT350
FM wire antenna
(aerial)
(supplied)
FM 75
Ω COAXIAL jack
Rear of the
subwoofer
ANTENNA
AM
FM
75 COAXIAL
Outdoor FM antenna
(aerial)
Rear of the
subwoofer