Southbend EB/10PC - Manual (Page 37)

E LECTRIC C ONVECTION O VENS
A
DJUSTMENTS
O PERATOR ’ S M ANUAL 1181958 P AGE 37
ADJUSTMENT
S
A
DJUSTMENTS
! WARNING
ADJUSTMENTS AND SERVICE WORK MAY BE PERFORMED ONLY BY A QUALIFIED
TECHNICIAN WHO IS EXPERIENCED IN, AND KNOWLEDGEABLE WITH, THE OPERATION OF
COMMERCIAL COOKING EQUIPMENT. HOWEVER, TO ASSURE YOUR CONFIDENCE,
CONTACT YOUR AUTHORIZED SERVICE AGENCY FOR RELIABLE SERVICE, DEPENDABLE
ADVICE OR OTHER ASSISTANCE, AND FOR GENUINE FACTORY PARTS.
NOTICE
Warranty will be void and the manufacturer is relieved of all liability if service work is performed by
other than a qualified technician, or if other than genuine Southbend replacement parts are installed.
LUBRICATION
The door chains and sprockets have been lubricated at the factory with high temperature “Never Seeze”
lubricant. After each six months of usage, lubricate the door chains and sprockets with the same type of
lubricant.
Motor lubrication information can be found on permanent label located on motor.
Casters are provided with a Zerk fitting for proper lubrication when required.
ADJUSTING DOOR CHAIN MECHANISM
The door chain mechanism causes the left and right doors to open and close together. To adjust the door
chain mechanism, do the following:
1. Remove lower front panel that covers the door chain mechanism (shown below).
2. Close both doors.
3. Check the positioning of the chain on the sprockets. There should be five regular links and one master
link visible on the front side of each chain. If not, open the turnbuckles and reposition the chain over the
sprockets.
4. Adjust the turnbuckles so that the right door closes about 1/4" to 1/2" inch ahead of the left door. The
left door should be pushed tight over the friction catch so both doors are completely closed against the
frame.
5. Secure the turnbuckles by tightening their locknuts.
ADJUSTING DOOR SWITCH
The door switch detects when the oven doors are open. As adjusted at the factory, when the doors are
opened more than 2 to 4 inches, the burners and fan should shut off (unless the fan is switched to “COOL”
mode). To adjust the door switch, do the following:
1. Remove lower front panel that covers the door chain mechanism.
2. Close both doors.