Symbol Technologies PL460 - Manual (Page 3)

Quick Reference Guide 3
Introduction
The PhaserLink 360/460 cradle acts as a stand, host communication interface,
and charger for the Phaser scanner. For convenience, the cradle can sit on a
desktop or be mounted on a wall.
The cradle receives data from the scanner via connectors in the bottom of the
scanner and the top of the cradle. It then transmits that data to the host device
through an attached cable.
The cradle also provides power for charging the scanner battery pack (in the
scanner). The cradle has a charge status indicator light.
Two versions of the cradle are available:
- PL 460 cradle: the batch retail version.
- PL 360 cradle: the batch industrial version.
This Quick Reference Guide provides basic instruction on the set up and use of
the cradle. Unless otherwise noted, the term PhaserLink refers to all versions of
the cradle.
Equipment Supplied
The following equipment is supplied:
- Two screws (for wall mounting).
- One Velcro strip (for desk mounting).
- Four rubber feet (for desk mounting).
- This Quick Reference Guide.
- PhaserLink cradle.
Save the shipping container for storing or shipping. Inspect all equipment for
damage. If anything is damaged or missing, call your authorized Customer
Support Representative immediately.
Related Documentation
- Phaser Series Scanner Product Reference Guide, p/n 70-33629-xx.
- P360/460 Memory Scanners Quick Reference Guide, p/n 70-33628-xx.