Symbol Technologies PL460 - Manual (Page 6)

6 PL360/460 Cradle
Wall Mounting
Before wall-mounting the cradle, the scanner support tab must be changed from
the desk-mount position to the wall-mount position.
Desk Mount Wall Mount
1. Lift the scanner support tab out of
the top part of the cradle and
replace it in the wall-mount
position as shown.
2. Seat the cables from the bottom of
the cradle in the grooves along the
length of the cradle so that the
bottom of the cradle is smooth and
flat.
3. Secure two screws (included) to
the wall. A template is provided on
page 14 .
- Fasten the screws into the wall
where the cradle should hang
leaving about 1/8” (.3 cm) of
the screw outside the wall for
the cradle wall moung sockets.
4. Place the cradle over the screw
heads and slide down until it fits
into place. Slight pressure
upwards should not move the
cradle.
5. Place the Phaser scanner in the
cradle.
1
2
3