Precautions, Additional information – Sony TC-WE625 User Manual

Page 18

Advertising
background image

18

EN

Additional Information

3-862-713-31(1)/CED/SP

Notes on Cassette Tapes

To protect a recording on side A or B

Break out the respective tab.

Precautions

On safety

• Do not disassemble the cabinet — this may result in an

electrical shock. Refer servicing to qualified personnel
only.

• Should any solid object or liquid fall into the cabinet,

unplug the tape deck and have it checked by qualified
personnel before operating it any further.

On power sources

• Before operating the tape deck, check that the operating

voltage of the tape deck is identical with your local power
supply. The operating voltage is indicated on the
nameplate at the rear of the tape deck.

• If you are not going to use the tape deck for a long time,

be sure to disconnect the tape deck from the wall outlet.
To disconnect the AC power cord, grasp the plug itself;
never pull the cord.

• AC power cord must be changed only at the qualified

service shop.

On operation

• Because of a safety mechanism, the function buttons will

not operate if the cassette holder is not completely closed,
if there is no cassette in the cassette holder, or if a cassette
has been incorrectly inserted into the cassette holder.

• Be sure to stop the tape before turning off the tape deck.

Otherwise, the tape may be damaged.

On placement

• Place the tape deck in a location with adequate ventilation

to prevent heat build-up in the tape deck.

• Do not place the tape deck:

— on a soft surface such as a rug that might block the

ventilation holes on the bottom.

— in a location near heat sources.
— in a place subject to direct sunlight.
— in an inclined position.
— in a place subject to excessive dust or mechanical shock.

On cleaning the tape deck

Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do not
use any type of abrasive pad, scouring powder or solvent
such as alcohol or benzine.

If you have any questions or problems concerning your
tape deck, please consult your nearest Sony dealer.

To record on a tape with a missing record-protect tab

Cover the respective tab hole with adhesive tape.

When you are using a type II or type IV tape, be careful not
to cover the detector slots that the deck uses to determine
the tape type.

Type II

Type IV

Detector slots

Detector slots

On tapes longer than 90 minutes

We do not recommend the use of tapes longer than 90
minutes except for a long continuous recording or playback.
They are very thin and tend to stretch easily.

On handling cassettes

• To prevent the heads and tape path from getting dirty,

avoid touching the tape surface of a cassette.

• Place cassettes away from equipment with magnets, such

as speakers and amplifiers, which may cause tape
distortion or erase the recordings.

• Do not expose cassettes to direct sunlight, extremely cold

temperature, or moisture.

Tab for side B

Side A

Tab for side A

Additional Information

7/18-23_TC-WE825S.31(1)EN

8/19/98, 4:25 PM

18

Advertising
This manual is related to the following products: