Sony NAC-SV10I - Manual (Page 16)

16 GB
Basic operations
This section explains the basic operations of the
unit.
Turning on this unit
1
Connect the AC power adaptor to
a wall outlet.
When you connect the AC power adaptor to a
wall outlet, the unit turns on once and the on/
standby indicator lights up in green. After a
while, the unit turns off automatically and the
on/standby indicator changes to red.
2
Press ?/1 (power).
The unit turns on and the on/standby
indicator lights up in green.
When the unit is turned on for the first time
after purchase, you are required to make the
initial settings. If this is the case, see
“Performing initial setup operations”
(page 20).
To turn off the unit
Press ?/1 on either the remote control or the main
unit. When the unit is turned off and enters the
standby mode, the color of the on/standby
indicator changes.
The unit has two standby modes, network standby
- off and network standby - on. For details, see
“Setting the network standby mode” (page 17).
• Network standby - off mode (factory
setting)
This standby mode consumes less power than
network standby - on mode, though the unit
takes more time to resume operations when
powered on again. The on/standby indicator
lights up in red in this mode.
• Network standby - on mode
In this standby mode, the unit is always
connected to the network and remains partially
active to quickly resume operations when
controlled over the network, or powered on
again. In this mode, the on/standby indicator
lights up in amber and the clock appears on the
display. To set the network standby mode, see
“Setting the network standby mode” (page 17).
To turn the Sony amplifier on or
off
You can use the remote control to control the Sony
amplifier (power on/off and volume).
For details on the remote control settings required
to operate the Sony amplifier, see “Setting up the
Sony amplifier” (page 19).
1
Press AMP ?/1 on the remote
control to turn on the amplifier.
2
Press AMP VOL – on the remote
control to turn the volume down to its
lowest level.
When you start playing the sound source on
the unit, press AMP VOL + to adjust the
volume from the amplifier.
3
Set the source selector on the
amplifier to the setting for this unit.
?/1
SETTINGS
FUNCTION
BACK
OPTIONS
M/m/ENTER
AMP ?/1
AMP VOL
+/–