Settings – Sharp Aquos TINS-E595WJQZ User Manual

Page 74

Advertising
background image

72

For the advanced setting (the setting of the
Ethernet connection speeds), press a/b to
select “Yes” or “No”, then press ENTER.

Normally select “No”, then press

ENTER.

The Ethernet connection speeds can be set when you
select “Yes”, then press

ENTER.

As automatic detection is made (factory preset
mode), this setting is not normally necessary. If a
situation occurs in which the Ethernet connection fails,
etc., change the setting and confirm if the Ethernet
connection successfully works.
When the connection speed is set, select “Next”, then
press

ENTER.

Option
Ethernet Connection Speeds

Next

Auto-Detection

10M Half Duplex

100M Half Duplex

10M Full Duplex

100M Full Duplex

For testing the connection to the Internet, after
confirming the settings, press a/b to select
“Test”, then press ENTER.

“Test” is available only when setting to obtain the IP
address automatically. “Test” cannot be selected if the
IP address has not been obtained automatically.

Confirm the current setting.

: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xxx xxx xxx xxx
: xx:xx:xx:xx:xx:xx

IP Address
Netmask
Gateway
DNS Address
MAC Address

Test

Complete

As a result of the test, if the Internet connection fails,
enter the setup values manually.

Press a/b to select “Complete”, then press

ENTER.

12


13

14

SETTINGS

Advertising
This manual is related to the following products: