Samsung VP-D200(i) - Manual (Page 34)

Adjusting the LCD during PLAY
✤ You can adjust the LCD during playback.
✤ The adjustment method is the same procedure as used in CAM mode. (see page 31)
The Speaker works in PLAYER mode only.
■ When you use the LCD screen for playback, you can hear recorded sound from
the built-in Speaker.
- Follow the instructions below to decrease or mute speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or mute the sound while playing a tape
on the camcorder.
1. Set the power switch to PLAYER mode.
2. Press
(PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play, use the MENU SELECTOR to adjust the
volume.
■ A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between 00 to 19 and you will not hear
any sound when the volume is set on 00.
■ If you close the LCD while playing, you will not hear sound from the speaker.
Notes
■ When the cable is connected to the AV jack, you cannot hear sound from the speaker and
cannot adjust the volume.
■ If a cable is connected to the AV jack, you can hear sound from the speaker when
AV IN/OUT MODE on MENU is set to AV IN. (VP-D200i/D230i/D250i/D270i only)
■ You can hear sound from speaker by removing the connected cable from the AV jack.
ENGLISH
Basic Recording
34 34
Controlling Sound from the Speaker
0 : 2 3 : 4 7
5 5 min
1 0 : 0 0
10 . J A N . 2 0 0 3
VOL. [ 1 1 ]
<3-2>
FADE
BLC
TAPE
EJECT OL/MF
MENU
S.SHOW
FADE
BLC
TAPE
EJECT VOL/MF
MENU
S.SHOW
FWD
2
3-1
00709E VP-D230(i) UK (28~60) 12/1/03 9:08 AM Page 34