Sharp Aquos LC 32G4U - Manual (Page 25)

25
Watching TV
Press a/b to select the desired language
listed on the screen, and then press ENTER.
Press c/d to select “Air” or “Cable” for ANT-
A, then press a/b to move down.
Press c/d to select “Air” or “Cable” for ANT-
B.
Press ENTER to enter the setting.
• This operation makes the System search for
both ANT-A and B.
• There are 3 kinds of CATV system, including
Standard, HRC and IRC. Select the one
matches to your system. Select Auto when you
do not know which one to select.
Initial setup
When you turn on the System for the first time, it will automatically memorize the broadcasting channels where
you live. Perform the following steps before you press TV POWER on the remote control unit.
1. Insert the batteries into the remote control unit. (See page XX.)
2. Connect the antenna cable to the AVC System. (See pages XX to XX.)
3. Plug in the AC cord to the AC outlet. (See page XX.)
Channel search
Channel auto search makes the System look for all
channels viewable in the set area.
3
1
2
Language
Air/Cable
CH Search English
Español
Français
Language
Air/Cable
CH Search ANT-A
ANT-B
Air
Cable (Auto)
CH Search
ANT-A [ ] 25 Air [ ] 20 Found
CH Search
ANT-B [ ] 25 Cable [ ] 20 Found
Language
Air/Cable
CH Search ANT-A
ANT-B
Air
Cable (Auto)
Example
2
ANT-A Air
Audio : MONO
Language setting
Select from among 3 languages: English, French and
Spanish.
Antenna setting
Make sure what kind of connection is made with your System
when selecting “Air” or “Cable” for both ANT-A and B.
Example
NOTE
• Make sure what kind of connection is made with your
System when selecting “Air” or “Cable” for both ANT-A
and B.
• If no channel is found, make sure what kind of connection
is made with your System and try EZ setup again (see
page XX).
• The illustrations and on-screen displays in this operation
manual are for explanation purposes and may vary slightly
from the actual operations.
Press c/d to select “Yes” for ANT-A, then
press a/b to move down.
Press c/d to select “Yes” for ANT-B, then
press a/b to move down to select “Search
Start” , and press ENTER.
Air/Cable
CH Search
CH Memory ANT-A Yes
ANT-B
No
Yes No
Search Start