Sharp Aquos LC 32G4U - Manual (Page 26)

26
Watching TV
Simple button operations for
changing channels
You can change channels in several ways.
NOTE
• While watching a broadcast, press ANT-A/B to view the
image received from the other tuner.
■ Using CHr/s on the remote control unit
• Press CH r r r r r to increase the channel number.
• Press CH s s s s s to decrease the channel number.
NOTE
• CH s/r on the Display operates the same as CHr r r r r/
s s s s s on the remote control unit.
■ Changing channels with CH r/s on the
remote control unit or CH
s/r on the
Display
Air: Press CH r and the channel change in the
order shown below:
2s3s...s68s69s2s3...
Press CH
s and the channel change in the
order shown below:
3s2s69s68s...s3s2...
Cable:Press CH r and the channel change in the
order shown below:
1s2s3s...s125s1s2s3...
Press CH
s and the channel change in the
order shown below:
3s2s1s125s...s3s2s1s...
■ Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons 0 to
9.
• The System allows you to select up to 125 channels
(1 to 125). To select a channel, enter a 2 or 3-digit
number.
NOTE
• When selecting a 1-digit channel number, do not fail to
press the 0 button.
To select a 3-digit channel number
(e.g., Channel 115):
Complete the following steps within 3 seconds.
Display
CH s/r
a
To select a 1 or 2-digit channel number
(e.g., Channel 5):
Complete the following steps within 3 seconds.
Press the 0 button.
• Complete the step 2 within 3 seconds after the
step 1.
Press the 5 button.
■ Using FLASHBACK on the remote control
unit
Press FLASHBACK to switch the currently tuned
channel to the previously tuned channel.
Press FLASHBACK again to switch back to the
currently tuned channel.
Press FLASHBACK to toggle between the currently
selected input source and the previously selected one.
NOTE
• FLASHBACK will not work if no channel has been
changed after the System is turned on.
Press the 1 button.
• Complete the step 2 within 3 seconds after the
step 1.
Press the 1 button again.
• Complete the step 3 within 3 seconds after the
step 2.
Press the 5 button.
1
1
2
1
11
115
3
2
3 Press ENTER to enter the setting.
• Channel selection will be made if there is no
operations for 3 seconds.
0
05
4 Press ENTER to enter the setting.
• Channel selection will be made if there is no
operations for 3 seconds.