Samsung ML-3560 Series - Manual (Page 39)

Using Print Materials
4.8
3
Load labels into the Multi-Purpose Tray with the print
side up. Adjust the guide to fit the width of the labels.
4
When you print, set the paper source, type, and size
properly in the software application. For details, see the
Software Section.
For details about setting on the control panel, see
page 3.2.
5
After printing, close the Multi-Purpose Tray and the rear
cover.
Printing on Transparencies
1
Open the Multi-Purpose Tray and pull the extender.
Guidelines
• Only use transparencies recommended for use in laser
printers.
• Ensure that transparencies are not wrinkled, curled, or have
any torn edges.
• Hold the transparencies by the edges and avoid touching the
print side. Oils from your fingers can cause print quality
problems.
• Be careful not to scratch or leave fingerprints on the print
side.
2
Open the rear cover and pull the extender.
3
Load transparencies in the Multi-Purpose Tray with the
print side up, and the top with the adhesive strip
entering the printer first. Adjust the guide to fit the
width of the transparencies.
4
When you print, set the paper source, type, and size
properly in the software application. For details, see the
Software Section.
For details about setting on the control panel, see
page 3.2.
5
After printing, close the Multi-Purpose Tray and the rear
cover.
N OTES :
• If you print on thin transparencies to the rear cover, they can
be curled. In this case, use the output tray. If the problem
persists, check if your transparencies meets the printer’s
specifications.
• To prevent transparencies from sticking, do not let the
printed sheets stack up as they are printed out.
• Place transparencies on a flat surface after removing them
from the printer.