Samsung HC-P5256W - Manual (Page 31)

English - 31
O P E R AT I O N
Storing Channels in Memory
œ The TV MUST be connected
to an antenna in order to
receive digital TV signals.
Even if a particular channel
is deleted from the memory,
you can always tune to that
channel directly by using
the number buttons on the
remote control.
6
Press the ENTER button to
start the auto program.
The TV begins memorizing
all available stations.
Press the ENTER button at
any time to interrupt the
memorization process.
Press the EXIT button to exit.
5
Press the ▲ or ▼
button to select the
antennas to memorize.
Press the ENTER button
to select “Start”.
4
Press the ▲ or ▼ button
to select the antenna
connection, then press the
ENTER button
When selecting Cable TV system:
Press the
▲ or ▼ button
to select “Cable”, then
press the ENTER button.
Press the
▲ or ▼ button
to select “STD”, “HRC” or
“IRC”, then press the
ENTER button.
Select the cable system.
STD
HRC
IRC
T V Auto Program
Auto Program in Process
AIR Channel 15
Stop
Auto Program
T V Auto Program
Select the antennas to memorize
Air
Cable
Air + Cable
Start
Start
Start
T V Auto Program
Select the antennas to memorize
Air
Cable
Air + Cable
Start
Start
Start
T V Auto Program
Select the antennas to memorize
Air
Cable
Air + Cable
Start
Start
Start
œ Air : “Air” antenna signal
Cable : “Cable” antenna
signal
Air+Cable : “Air” and “Cable”
antenna signals
œ If the CableCARD is inserted
into the “CableCARD” slot on
the rear panel, “Cable” and
“Air+Cable” are not available.
œ STD, HRC and IRC
identify various types of
cable TV systems. Contact
your local cable company
to identify the type of cable
system that exists in your
particular area. At this
point the signal source has
been selected. Proceed to
“Storing Channels in
Memory”.
• All available DTV and analog channels are automatically stored
in memory when channels are selected by the direct tuning
function.
BP68-00334A-00Eng 5/20/04 4:54 PM Page 31