Sharp XE-A303 - Manual (Page 13)

11
Part
1 QUICK START GUIDE Part
2
Part
3
6. Cut off the excess paper using the edge of the inner cover.
7. Lift up the print roller release lever
(indicated as "PULL" on it) of the journal
side to unlock and open the print roller
arm. Then, set a paper roll in the paper
roll cradle of the journal side as per the
diagram in the Step 3.
8. While holding down the paper, slowly close the print roller arm of the
journal side, and push down the arm until you hear a click locking
the arm. Make sure securely you push down the center of the wing
part of the arm as per the diagram. The paper will be automatically
fed.
9. Insert the end of the paper into the slit in
the spool. (Press the
} key to feed
more paper if required.)
10. Wind the paper two or three turns around
the spool shaft.
11. Set the spool on the bearing, and press the } key to take up
excess slack in the paper.
12. Replace the printer cover.
13. Press the { key to make sure the paper end comes out of the
printer cover and clean paper appears.
Print roller arm
(Journal side)
Print roller release lever
(Journal side)
A303_1(En) 06.7.22 9:20 AM Page 11