Sony CDX-F7705X - Manual (Page 26)

26
Connecting auxiliary audio
equipment
The unit’s AUX IN (external audio input)
terminal on this unit is also used as the BUS
AUDIO IN (audio input) terminal.
You can listen to the sound from your car
speakers by connecting optional Sony portable
devices.
Note
If you connect an optional Sony CD/MD unit, you
cannot connect any portable devices and “AUX” will
not appear in the display as a source.
When you connect a Sony portable device and CD/
MD unit(s) at the same time, use the AUX IN selector.
Selecting auxiliary equipment
Press (SOURCE) repeatedly to select
“AUX.”
Adjusting the volume level
You can adjust the volume for each connected
audio equipment.
1
Press (MENU) .
2
Press M or m repeatedly to select
“AUX Level.”
3
Press (ENTER) .
4
Press M or m repeatedly to select a
desired volume level.
The volume level is adjustable in 1 dB steps
from –6 dB to +6 dB.
5
Press (ENTER) .
To deactivate auxiliary equipment in
the source display
1
Press (OFF) .
CD playback or radio reception stops.
2
Press (MENU) .
3
Press M or m repeatedly until “AUX-A-
on” appears.
4
Press , to select “AUX-A-off.”
5
Press (MENU) .
To restore the indication, select “AUX-A-on.”
Additional Information
Maintenance
Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse blows
again after replacement, there may be an internal
malfunction. In such a case, consult your nearest
Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front panel
are not clean. In order to prevent this, detach the
front panel (page 10) and clean the connectors
with a cotton swab dipped in alcohol. Do not
apply too much force. Otherwise, the connectors
may be damaged.
Notes
• For safety, turn off the ignition before cleaning the
connectors, and remove the key from the ignition
switch.
• Never touch the connectors directly with your fingers
or with any metal device.
Fuse (10 A)
Main unit
Back of the front panel