Sony CPD-G520 - Manual (Page 17)

17
US
C:\DATAFOLDER\##sagyou##\##01 Jan\407977133CPDG520UC\US\01US04BAS-UC.fm masterpage:Right
CPD-G520
4-079-771-33 (1)
CPD-G520
4-079-771-33 (1)
Resetting the adjustments (RESET)
This monitor has the following 2 reset methods.
x Resetting all the adjustment data for the
current input signal
1 Press the MENU button.
The menu appears on the screen.
2 Move the control button up or down to highlight
0 RESET and press the control button.
3 Move the control button up or down to select 0 1
and press the control button.
4 Move the control button up or down to select OK
and press the control button.
Note that the following items are not reset by this method:
• on-screen menu language (page 8)
• color mode setting in the OPTION menu (EASY, PRESET,
EXPERT, sRGB) (page 14)
• color temperature setting in the PRESET mode (5000K,
6500K, 9300K) (page 15)
• on-screen menu position (page 16)
x Resetting all of the adjustment data for all
input signals
Select 0 2 in step 3 above.
Note
The RESET function does not function when (CONTROL LOCK)
is set to ON.
Technical Features
Preset and user modes
When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
monitor’s memory to provide a high quality picture at the center
of the screen. (See Appendix for a list of the factory preset
modes.) For input signals that do not match one of the factory
preset modes, the digital Multiscan technology of this monitor
ensures that a clear picture appears on the screen for any timing in
the monitor’s frequency range (horizontal: 30 – 130 kHz, vertical:
48 – 170 Hz). If the picture is adjusted, the adjustment data is
stored as a user mode and automatically recalled whenever the
same input signal is received.
Note for Windows users
For Windows users, check your graphics board manual or the
utility program which comes with your graphics board and select
the highest available refresh rate to maximize monitor
performance.
Power saving function
This monitor meets the power-saving guidelines set by VESA,
E NERGY S TAR, and NUTEK. If no signal is input to the
monitor from your computer, the monitor will automatically
reduce power consumption as shown below.
* When your computer enters power saving mode, the input signal is
cut and NO SIGNAL appears on the screen before the monitor enters
active off mode. After a few seconds, the monitor enters power saving
mode.
** “Deep sleep” is power saving mode defined by the Environmental
Protection Agency.
MENU E
RESET
1
2
X I T :
CURRENT
MODE
CANCEL
OK
Power mode Power consumption ! (power)
indicator
normal
operation
≤
135 W green
active off*
(deep sleep)**
≤
3 W orange
power off Approx. 0 W off